HP6000ZB-GE model
HP6000ZB-GE model
Here is a detailed step-by-step guide that will take you through the installation of your HP6000ZB-GE ductless heat pump interface.
The installation of the ductless heat pump interface must be performed by a qualified professional. Otherwise, it may result in personal injury and/or damage.
Make sure that the breakers for your heating system are off at the main electrical panel to avoid any risk of electric shock.
Open the front panel of the indoor unit.
Remove the screw(s) to access the electrical box, then remove the cover. Locate the Wi-Fi connector and cable.
Remove the wire clip.
Route the interface wire into the electrical box and
connect it to the unit’s Wi-Fi connector.
Place the interface on the mounting location.
Secure the interface with the provided screw.
The interface mounting location varies from model to model. Here are the common mounting locations. Choose the one that best fits your model.
Note: The Wi-Fi module wire must be routed through the wire channel; otherwise, the electrical box cover will not close properly.
Replace the electrical box cover and secure it with a screw.
Power up the heat pump.
You will find below the most common issues you may encounter.
If you still need help, contact Sinopé technical support.
Install a thermostat myself (DIY)
How to determine the polarity of the wires
Difference between a single-pole thermostat and a double-pole thermostat
Connection of a single-pole thermostat with a four-wire installation
Calculate the thermostat wattage required to control your electric heaters
Difference between TRIAC and relay switching
Installation of the thermostat with multiple heating devices in the same room
Installation of a wire connector
How a proportional thermostat works
Difference between short cycle and long cycle control
What if I am having difficulty connecting my Wi-Fi thermostat to the Wi-Fi network?
Ce site est offert dans d'autre langue. Veuillez choisir votre préférence.
