Install a smart water leak detector
Proceed as follows to install your smart water leak detector
Install the smart water leak detector
Proceed as follows to install your smart water leak detector
Installing your device
near risky areas
Make sure you have all the items that are included in the box
- Sedna DS water leak detector with 4-ft sensor
- Installation guide – French version
Installation guide – English version - 2 AAA lithium batteries
- 2 screws
Follow the installation steps
Here is a detailed step-by-step guide that will take you through the installation of your smart water leak detector.
1
Connect the sensor to the detector.
2
Attach the detector to a clean surface where there is no risk of immersion. Use the provided screws or the non-permanent adhesive located on the back of the product.
3
Put down the sensor or attach it to the wall. The electrodes must face the ground.
4
Test the detector by putting the electrodes in contact with a small amount of water (1 tsp). The audible alarm will be activated. Wipe the electrodes with a dry cloth to cease the alarm.
Connection to Sinopé's smart water valve
Here is a detailed step-by-step guide that will take you through the connection of your smart water leak detector with the Sinopé smart water valve.
1
The mode switch of the valve must be in position « 1 ». The valve must be plugged into a power outlet.
2
Press the « B » button to open the network connectivity session for the detectors. The indicator lights will light up in sequence to indicate that the session is active.
3
Connect the detector to the network from its installation location. This will ensure it is within range of RF signal of the valve. Remove the cover and insert the batteries.
4
Press the detector’s connection button.
| Light | Status |
| Green light blinks | Device is connecting |
| Green light lit for 10 s | Successful connection |
| Red light blinks | Connection has failed |
5
Press the « B » button on the valve to close the connectivity session.
The connection can be verified at any time by pressing the water leak detector’s button. The indicator light will light up in green for 10 seconds if the unit is connected.
Connection to a Zigbee compatible system
It is also possible to connect your water leak detector to a Zigbee compatible system.
Get to know your smart water leak detector
You can now start configuring your water leak detector.
Look for more topics
You will find below the most common issues you may encounter.
If you still need help, contact Sinopé technical support.