Install a non-programmable floor heating thermostat

Proceed as follows to install your non-programmable floor heating thermostat

Install a non-programmable floor heating thermostat

Proceed as follows to install your non-programmable floor heating thermostat

Installing your thermostat
on the wall

Make sure you have all the items that are included in the box

Non-programmable floor heating thermostat
Installation guide – English version
Installation guide – French version
2 screws
2 wire connectors
Floor sensor (15 ft)

You will also need:

Square or flat screwdriver
Wire stripper (optional)

Follow the installation steps

Here is a detailed step-by-step guide that will take you through the installation of your floor heating non-programmable thermostat.

The installation of this thermostat must be performed by a certified electrician and comply with the national and local electrical codes and regulations.

The warranty does not cover damage to the thermostat due to improper installation. Special CO/ ALR solderless connectors must be used when connecting with aluminum conductors.

Make sure that the breakers for your heating system are off at the main electrical panel to avoid any risk of electric shock.

Unlock and lift the thermostat cover.

Connect the heating floor by using the 3 load / line wire connectors located on the back of the thermostat. Connect the ground wire to the screw in the electrical box intended for this purpose.

Make sure to firmly tighten the wire connectors for a secure connection. A loose connection can be a fire hazard.

Connect the sensor. (Only for control applications in F mode or with floor limit.)

Use the screws to secure the thermostat to the electrical box. Replace the cover and lock.

Power up the thermostat. After performing a test sequence, the thermostat should display the floor temperature. If not, refer to the troubleshooting guide in this manual.