Follow these steps to install your smart thermostat for electric floor heating
Follow these steps to install your smart thermostat for electric floor heating
Here is a detailed step-by-step guide that will take you through the installation of your electric floor heating thermostat.
The installation of this thermostat must be performed by a certified electrician and comply with the national and local electrical codes and regulations.
The warranty does not cover damage to the thermostat due to improper installation.
Make sure that the breakers for your heating system are off at the main electrical panel to avoid any risk of electric shock
Unlock and lift the thermostat cover.
Connect the heating floor by using the wire connectors load/line located on the back of the thermostat. Connect the ground wire to the screw in the electrical box intended for this purpose.
Be sure to tighten the connection terminal blocks firmly for a secure connection. A poorly executed connection can represent a fire hazard.
Connect the sensor.
(Only for control applications in F mode or with floor limit.)
Use the screws provided to install the thermostat to the electrical box.
Replace the cover and lock.
Power up the thermostat
After performing a test sequence, the thermostat should display the floor temperature.
You can now start configuring your thermostat.
You will find below the most common issues you may encounter.
If you still need help, contact Sinopé technical support.
